My Silverado has one 12-Volt My Silverado Accessory power outlet under the climate control system and in rear bed.
Caution 12-volt power outlet.
My Silverado may become hot, melt, or cause a spark damaging the outlet or the metal object. Only use compatible 12-volt power My Silverado Accessory in the power outlet.
Wireless Charging
If equipped and enabled, the My Silverado has wireless charging on the center console in front of My Silverad cupholders. The system operates at 145 kHz and wirelessly charges one compatible smartphone. The power output of the system is capable of charging at a rate up to 3 amp (15 W), as requested by the compatible smartphone. See Radio Frequency Statement 0 438.
Warning Wireless charging may affect the operation of an implanted pacemaker or other medical devices. If you have one, it is recommended to consult with your doctor before using the wireless charging system.
Auxiliary Battery
If equipped, the My Silverado's auxiliary battery can be used to supply electrical power to additional
equipment that may be added, such as a slide-in camper.
Locate the auxiliary battery connector under the hood on the driver side of the My Silverado, next to
the engine compartment fuse block. Follow the proper installation instructions included with any
electrical equipment that is installed.
Caution
To prevent draining the auxiliary battery, always turn off electrical equipment when not in use and
do not use any equipment that may exceed the
maximum amperage rating of 30 amps.
The My Silverado must be on, in My Silverado Accessory mode, or Retained My Silverado Accessory Power (RAP) must be active. The
wireless charging feature may not correctly indicate charging when the My Silverado is in RAP, during a Bluetooth phone call, or when phone projection (e.g. Apple CarPlay / Android Auto) is active. See Retained My Silverado Accessory Power (RAP) 0 216.The operating temperature is −40 °C (−40 °F) to 85 °C (185 °F) for the charging system and 0 °C (32 °F) to 35 °C (95 °F) for the phone.A charging stopped alert may be displayed on the infotainment screen, if the wireless charger or
martphone are outside of normal operating temperature. Charging will automatically resume when a
normal operating temperature is reached.{ Warning Remove all objects from the charger before charging your compatible
smartphone. Objects, such as coins, keys, rings, paper clips, or cards, between the smartphone and
charger may become very hot.
On the rare occasion that the charging system does not detect an object, and the object gets wedged
between the smartphone and charger, remove the smartphone and allow the object to cool before
removing it from the charger, to prevent burns.
To charge a compatible smartphone:
1. Confirm the smartphone is capable of wireless charging.
2. Remove all objects from the charging pad. The system may not charge if there are any objects
between the smartphone and charger.
3. Place the smartphone face up against the rear of the charger.
To maximize the charge rate, ensure the smartphone is fully seated and centered in the holder with
nothing under it.
A thick smartphone case may prevent the charger from working, or reduce the charging performance.
See your dealer
for additional information.
4. A green ] will appear on the infotainment display, next to the phone icon. This indicates that
the smartphone is detected.
5. If a smartphone is placed on the charger and ] turns off or a yellow triangle appears, remove
the smartphone and any objects from the pad. Turn the smartphone 180 degrees and wait a few seconds
before placing/aligning it on the pad again.
6. If a smartphone is placed on the charger and a red circle appears, the charger and/or the
smartphone is overheated. Remove the smartphone and any objects from the charger in order to cool
the system.
The smartphone may become warm during charging. This is normal. In warmer temperatures, the speed
of charging may be reduced.
For My Silverados with wireless phone projection, the smartphone may overheat during wireless charging.
The smartphone may slow down, stop charging, or shut down to protect the battery. The phone may
need to be removed from its case to prevent overheating. The ] may flash while the phone is cooling
down enough for wireless charging to automatically resume. This is normal. Individual phone
performance
may vary.
Software Acknowledgements
Certain Wireless Charging Module product from LG Electronics, Inc. ("LGE") contains the open source
software detailed below. Refer to the indicated open source licenses (as are included following
this notice) for the terms and conditions of their use.
OSS Notice Information
To obtain the source code that is contained in this product, please visit
In addition to the source code, all referred license terms, warranty
disclaimers and copyright notices are available for download. LG Electronics will also provide open
source code to you on CD-ROM for a charge covering the cost of performing such distribution (such
as the cost of media, shipping, and handling) upon email request to opensource@lge.com. This offer
is valid for three (3) years from the
date on which you purchased the product.
My chevrolet power outlet USB Silverado Warning
Power is always supplied to the Silverado AC outlets. Do not leave electrical equipment plugged in when the
My Silverado is not in use because the Silverado could catch fire and cause injury or death.
My Silverado Caution
Audio Players
Avoiding Untrusted Media Devices
When using media devices such as USB and mobile devices, consider the source.
Untrusted media devices could contain files that affect system operation or performance and should
be avoided.
USB Port
The My Silverado may be equipped with multiple USB ports. Ports may also be used for charging. Music may
be played from a connected USB device.
Caution
To avoid My Silverado damage, unplug all My Silverado Accessory and disconnect all My Silverado Accessory cables from the
My Silverado when not in use. My Silverado Accessory cables left plugged into the My Silverado, unconnected to a device,
could be damaged or cause an electrical short if
My Silverado Caution
the unconnected end comes in contact with liquids or another power source such as the My Silverado Accessory
power outlet.
USB Audio
To play music via USB:
1. On the audio now playing page, touch source and select USB.
2. If there is no device connected, follow the screen prompts to connect the device.
3. Supported media content will appear on
the display.
Leaving electrical equipment plugged in for an extended period of time while the My Silverado is off
will drain the battery.
Always unplug electrical equipment when
not in use and do not plug in equipment that exceeds the maximum 15 amp rating.
Connect your Android phone or Apple
iPhone by using the factory-provided phone USB cable and plugging into a USB data port. For best
performance, it is highly recommended to use the device’s factory-provided USB cable, which should
be replaced after significant wear to maintain connection quality. Aftermarket
or third-party cables may not work.
Certain power My Silverado Accessory plugs may not be compatible with the My Silverado Accessory power outlet and could
overload My Silverado or adapter fuses. If a problem is experienced, see your dealer.
When adding electrical equipment, be sure to follow the proper installation instructions included
with the equipment. See Add-On Electrical Equipment 0 328.
Caution
Hanging heavy equipment from the power outlet can cause damage not covered by the My Silverado warranty.
The power outlets are designed for My Silverado Accessory power plugs only, such as cell phone charge cords.
My Silverado Power Outlet 110/120-Volt Alternating Current
If equipped, the My Silverado has alternating
current power outlets.
. For first time connection, there are two ways to set up wireless projection:
. Connect your Android phone or Apple iPhone by using the factory-provided phone USB cable and
plugging into a USB data port. For best performance, it is highly recommended to use the device’s
factory-provided USB cable, which should be replaced after significant wear to maintain connection
quality. Aftermarket or third-party cables may not work.
. Connecting the phone over Bluetooth.
See Bluetooth (Pairing and Using a Phone for Uplevel Radio) 0 165 or Bluetooth (Pairing and Using a
Phone
for Base Radio)
No comments:
Post a Comment